page

News

Caster Durability: Why the Chair Leg Must Carry No Vertical Force During the Test

The casters on an office chair are tested by rolling, and only by rolling. If the test rig pushes down on the chair while it rolls, the result measures a vertical load the standard never asked for. A swivel chair caster durability testing machine is defined by how cleanly it keeps that unwanted vertical force out of the measurement.

Castors fail by rolling, not by standing

A caster wears at its stem, its bearing and its wheel tread — and all three wear through motion. The test that exposes that wear is a loaded chair rolling over an obstacle or threshold strip, cycle after cycle, until the stem bends, the bearing loosens or the tread delaminates. It is a rolling test, and the load is meant to come from the chair’s own weight, not from the machine pressing down.

Introduce a vertical press force into the rig and the result changes meaning. The caster is now being compressed as well as rolled, and the failure the test reports may be a compression failure that would never occur in real use. Clean loading is the difference between a caster test and a caster-shaped demonstration.

How the machine keeps the load pure

Three design choices do the work:

  • A self-centring clamp holds the chair by its legs, keeping the chair legs and casters free of vertical force. The chair rotates, but it is not pushed down.
  • A universal joint at the output end adapts to different seat angles, so the drive force is transmitted as rotation rather than as a downward component against an angled seat.
  • A precision pressure regulator holds the cylinder output stable, and an adjustable force height matches different chair heights — so the applied force stays where the standard puts it, not where gravity drifts it.

A motor-driven rotating platform with multi-speed VFD control rotates the chair through a selected angle in reciprocating or single-direction modes. That choice of motion matters: reciprocating rotation stresses the caster differently from continuous single-direction rotation, and the standard distinguishes the two.

What the standards frame

Caster and base durability sits in BIFMA X5.1-2017 alongside the swivel-spindle and base-pedestal clauses, with QB/T 2280-2016 and EN 1335:2000 providing the domestic and European frames. Each standard specifies its own cycle count and load condition for the caster, and the bench must reproduce them without adding a vertical force the clause does not call for.

Element Why it keeps the result honest
Self-centring clamp Holds the chair without pressing down, so casters carry only rolling load
Universal joint Transmits rotation, not a downward component, across seat angles
Adjustable force height Matches the drive force to each chair height, keeping load where specified
Multi-speed VFD Reciprocating vs single-direction rotation, as the standard distinguishes

For a Lituo machine aimed at chair manufacturers and export work, the decisive capability is that the caster is tested under the load the standard specifies, and nothing else. That is what separates a durability result a buyer can defend from a cycle count with no meaning.

Why must the chair leg carry no vertical force?

Because the caster durability test is a rolling test. Adding a downward force introduces a compression load the standard never asked for, and changes what the result means.

What is the universal joint for?

It lets the drive force adapt to different seat angles while transmitting rotation rather than a downward component against the seat.

Does reciprocating or single-direction rotation matter?

Yes. They stress the caster differently, and the standard treats them as separate conditions, so the machine must be able to run both.

Which standards should I reference?

BIFMA X5.1-2017, QB/T 2280-2016 and EN 1335:2000, each with its own caster clause. Confirm the current edition before specifying limits.


Post time: Nov-17-2026